11-21-2013 02:26 PM - edited 07-04-2021 01:18 AM
Anyone out there have a way to run a "report" to see FlexConnect Vlan Mappings on Access Points? I troubleshoot alot of different sites and looking at each AP individually is very tediuos and time consuming.
11-22-2013 06:14 AM
What I have done is run a show run-config and then use a good text editor to parse the various different FlexConnect vlan mappings. So basically I will parse the native vlan, then WLAN 1, WLAN 2, etc. that's the only way I have done it.
If I know that some of these values defaulted back, I don't even try to figure which one is wrong, I paste a config or use WCS, NCS or PI to put the correct value in.
Sent from Cisco Technical Support iPhone App
11-22-2013 06:17 AM
Here is a thread in which I attached some files to be able to paste commands into the WLC cli to change the WLAN to vlan mappings.
https://supportforums.cisco.com/thread/2221117
Sent from Cisco Technical Support iPhone App
11-25-2013 02:35 AM
Please check the below link for FlexConnect Vlan Mapping’s configuration:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide