FlecConnect Report?

[adrews]

Anyone out there have a way to run a "report" to see FlexConnect Vlan Mappings on Access Points?   I troubleshoot alot of different sites and looking at each AP individually is very tediuos and time consuming.

[Scott Fella]

What I have done is run a show run-config and then use a good text editor to parse the various different FlexConnect vlan mappings. So basically I will parse the native vlan, then WLAN 1, WLAN 2, etc. that's the only way I have done it.

If I know that some of these values defaulted back, I don't even try to figure which one is wrong, I paste a config or use WCS, NCS or PI to put the correct value in.

Sent from Cisco Technical Support iPhone App

[Scott Fella]

Here is a thread in which I attached some files to be able to paste commands into the WLC cli to change the WLAN to vlan mappings.

https://supportforums.cisco.com/thread/2221117

Sent from Cisco Technical Support iPhone App

[aqjaved]

Please check the below link for FlexConnect Vlan Mapping’s configuration:

http://www.cisco.com/en/US/docs/wireless/controller/7.3/configuration/guide/b_wlc-cg_chapter_01110.pdf