
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-29-2017 07:53 AM - edited 07-05-2021 08:02 AM
Hello, at a remote office we have couple of AP's serving some clients. The APs are in Flexconnect mode connecting to the WLC over the MPLS and internet traffic is also being backhauled through the MPLS. Is there a way we can have the AP's connect to the WLC over the MPLS but use the remote office internet circuit for outside access?
Solved! Go to Solution.
- Labels:
-
Aironet Access Points
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-03-2018 08:36 PM
This was fixed by ticking the flexconnect checkbox under the wlan options.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-03-2018 08:36 PM
This was fixed by ticking the flexconnect checkbox under the wlan options.
