Hey Community! I'm excited to share something we've been working on that I think will really resonate with many of you managing wireless networks today. We just released the Cisco State of Wireless Report 2026, based on insights from over 6,000 wirel...
Forum Posts
I have a cisco WLC model AIR-CT2504-K9 on version 8.3.143.0 serving as local WLC and anchor WLC AIR-CT5508-K9 running on version 8.0.152.0.I am planning to put another local WLC model AIR-CT2504-K9 version 8.0.133.0 to form EOIP tunnel with this a...
Good morning, We have a client with packet loss and delay in the wireless network. The client is near the ME AP (56 dBm aprox.) Attached is a picture with a ping to a DNS server. Also, sometimes we get reported about client disassociation. T...
Dears, I have Cisco AIR-CAP2702i-E-K9 access point and it was perfectly working till yesterday through PoE without any issues. suddenly it's stopped and when I checked with console cable there is no response from AP and the LED is Off.Just now I have...
I am trouble shooting some wireless issues. Before I make the changes I am gathering the data from the AP's I am working with. So that I have a clear and accurate account to compare with after the changes are made. That said, I am using the details f...
Hi Tech guys, i have 3 5520 WLC in different Locations,WLC are in Standalone deployement. Building 1 ==== WLC 5520 (20 Access point)Building 2=====WLC 5520 (20 Access point)Building 3=====WLC 5520 (20 Access point) i have questions that if i buy ...
Hi All, Recently i have a problem with the deployment. I have just get a Mobility Express version AIR-AP1852i-K-K9C. And i have 1 internet speed with 800Mbps. but when after change to 1852i, i just able to get 200 - 400Mbps (Rarely to get 500Mbps a...
Resolved! OfficeExtend Support on 2800 series APs
Can anyone confirm if the 2802i APs support OfficeExtend (OEAP) mode? Looking at the deployment guide for the 1700/2700/3700 APs states:All the standard modes are supported:Local modeFlex ModeOEAP Modehttps://www.cisco.com/c/en/us/td/docs/wireless/te...
Resolved! WLC upgrade guide
Hi Please provide WLC upgrade documentation. Thank you
good afternoon everyone, is there any way to create guest ssid for guest internet access without controller and vlans? I'm trying to see if i could configure it this way so it can be connected to any router and provide basic separation from main and ...
Can anyone tell me where I can manually renew dhcp ip from AP2802I want AP2802 dhcp release or renew ip ,thanks
Resolved! How to connect and configure WLC 2500
llo everybody,Please see file attachedI am trying to setup a wifi network but I have been struggling to get it working.I am not sure how to interconnect the hardware so I made a drawing to illustrate what I have and what I want to do.I have a Meraki ...
hi every one, right now i have problem with a bridge 1310g i can't console it at allwhen i did it give blank screentried two different cables and i did use the com port with a different device and it is totally working but no luck with the bridge...
Hello.I have a 3504 with 8.5.131.0 software. I have a few AIR-AP1815I-B-K9 connected but I am also trying to get my previous AIR-CAP1602I-A-K9 to connect. In the past the AIR-CAP1602I-A-K9 were connected to 2500 WLC. Is it possible to convert the AIR...
Resolved! Problem with vWLC and AIR-CAP3602I-A-K9
Hi guys finally got my vWLC working and now I'm stuck with these Lightweight AP's that don't want to join. I got 3 all same models except one is equipped with AIR-RM3000M either way non of them wants to join my vWLC. Before I had some certificate iss...
Hello We have a corporate network where we facing some issues with the access point 2600 series . . The problem is like this - The ap-s that are using channels from UNII3 are not working for Corporate network but they can connect to GUEST network ....
