09-05-2012 02:39 PM - edited 07-03-2021 10:37 PM
After installing Certificate on NGS , Guestconnect wireless connection is dead slow. (takes more than 1 minute to load Splash page ,which is stalled on NGS)
We have another Anchore controller with NGS in DR site. Whenever we pointing WLC to DR Anchor controller ,no issue.
Any help is highly appreciated.
Thanks
Sri
09-05-2012 03:14 PM
Are they using the same NGS? Are there any half duplex links in the path?
Steve
Sent from Cisco Technical Support iPhone App
09-05-2012 03:28 PM
not the same NGS. which was working fine before certificate installation.
Problem started after installing the certificate. then we diverted the traffice to our DR site( no issue here).
09-06-2012 12:44 PM
The certificate shouldn't cause this, unless there is an issue getting to the Internet to validate the certificate.
It could still be a duplex issue between the NGS and the Internet connection at the non-DR site.
Steve
Sent from Cisco Technical Support iPhone App
09-06-2012 01:37 PM
As I said before, only Guest connect authentication request takes more than 1 minutes(takes more than 1 minute to load Splash page ,which is stalled on NGS) .
Once the auth is successfuly , users can access internet normally.
09-16-2012 12:45 PM
You want to be certain, sniff the guest traffic and see what is being delayed.
__________________________________________________________________________________________
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
09-16-2012 02:41 AM
Are u natted? Could be cert validation issue. Turn off ocsp checking on ur browser c how it goes
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide