07-17-2024 09:31 PM
Hey guys,
I need some assistance with my Catalyst 9115AXI AP. I accidentally disabled the "Enable Layer 3 Address" in Configuration-Interface-Ethernet via the WebUI, and now I can't access the WebUI or ping the IP address. I decided to reset the device and connected a console cable to the controller to access the CLI, but it keeps looping the same output. please see attached screenshot. This is the controller
Does anyone have any suggestions on how to resolve this?
07-17-2024 11:09 PM
- What mode is the AP intended to be used : EWC or CAPWAP ap ?
M.
08-03-2024 03:40 PM
Use the AP mode button to reset the AP to factory default then reconfigure.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide