Help please

[george]

i have LWAP 1242

the problem is when i type config t it shows me an error of typing and i can't go on

could you help me please

[Surendra BG]

Hi George,

U need t oconvert the image on the AP to Autonomous.. here is the doc written by me and this will help u out in getting the issue resolved!!

https://supportforums.cisco.com/docs/DOC-14960

Please dont forget to rate the usefull posts!!

Regards

Surendra

[george]

Hello Surendra

first of all thank you for your reply

why i have to convert my image to autonomous ?

this is the only solution for my problem ? if so when i checked the steps, i saw that i have to type config t and as i

explain for you i can't type config t

thank you

regards

[Surendra BG]

Yes u need to re image to Autonomous.. To convert please issue the hidden debug command and then convert.. please follow the exact steps.. i guess ur missing the main command..

AP>en

AP#debug lwapp console cli or debug capwap console cli

after this command u will be able to go into the conf t and then convert the image using the next following steps..

Follow the instructions!! and please dont forget to rate the usefull posts!!

Regards

Surendra

[george]

thank you a lot

i will try it