Wireless

Can I Deployed a wireless mesh w/o WCS? is it necessary? I  have 5 1550 AP, WLC (12 AP license) and 1 Catalyst Switch. With all these can I Install a wireless mesh.Thanks

Hi Guys,Trying to get an lightweight AP to register with a controller, never seen this one before where the Discovery request is going out to the controller, the discovery response is coming back, but then nothing. At this point the AP should then se...

Hi NG,i'm currently trying to configure a AP801AGN-E-K9 sitting within a 892W router.it was working previously with the following config, i just don't find it!!!service-module wlan-ap 0 bootimage unifiedinterface Loopback0ip vrf forwarding XXXip addr...

Hi - We can not set up peer to peer communications to share files through the wireless connection, same AP. Peer to peer works with wired connections. Using DHCP with Windows 7 OS on laptopsThanks!!Mike

Hi Guys,My Customer is having the following problem:He has Mobil Phone 7921 and 7925Versão de firmware dos Telefones 792x CP7921G-1.3.3.LOADS  CP7925G-1.4.1.LOADS WLC Version Primary Boot Image............................... Code 6.0.188.0 He is spea...

Hello Guys,I have a 5508 WLC controller at the HQ with the employee ssid ,the dhcp scope on the ssid is 10.120.0.0/16 network.However,I want this same ssid to be brodcasted to a remote site using HREAP access point but with  different dhcp scope 10.1...

I have 3 Cisco 350 Series AP 12.00T.  in the setup menu under AP Radio Advanced 2 of them say Forwarding State Forwarding. 1 AP says Forwarding State Blocking. When attempting to connect to the blocking AP through a workstation the connection is alwa...

Hi,I need to block a single port on my wan side fa0/1 .. my telnet port 23 as it is open and im not going to use it and want to close it ?thank you

Hi, i have a request to provide very simple reports about unique wifi devices accessing wifi, based on location and for last month. I am running WCS 7.0172 and cannot find simple report like this. The Cleint session report detail has all these detail...

If you don't need or want the ability to configure the switches using NCS, can you just license the NCS based on the number of APs.  Or,  must you license for all APs AND all switches that they are attached to.  Its not clear in the documentation if ...

One of our customer already has 1131AG (AIR-AP1131AG-A-K9) AP and they would like to install and configure 3 more. This is Autonomous one but question I have is if we really need Cisco Works WLSE and what would be its benefits to the customer in case...

The compatibility matrix shows no support for a Location Appliance 2700 for any version 7.0.x.x for WCS and WLC. However, I did see a thread here where a v6.0.x.0 had compatibility. v6.0.202.0 is MD. Is it compatible with v7 WCS and WLC?Can any of th...