How Are Your Controllers Setup for BYOD/Guest and OEA

[bret]

I am in the process of building a new wireless network. The network will include BYOD/Guest and OEA for teleworkers using ICE and MobileIron for MDM. In the past I have setup an anchor controller for guest, but for this design I have a cost constraint that prevents me from adding the anchor controller. I know the Cisco SE’s push to include an anchor controller in the DMZ for this design, but I wanted an unbiased opinion from folks who may have a similar design and how your controllers are setup. For this design can I deploy a BYOD/Guest and OEA network without a DMZ controller?

Thanks in advance.

Bret

[Sandeep Choudhary · Accepted solution]

Hi Bret,

You can use WLC with Cisco ISE.

Here is the full deployment guide:

http://www.cisco.com/image/gif/paws/113476/wireless-byod-ise-00.pdf

http://www.cisco.com/en/US/products/ps10315/products_tech_note09186a0080bba10d.shtml

http://www.cisco.com/en/US/docs/solutions/Enterprise/Borderless_Networks/Unified_Access/BYOD_ISE.html

Hope it helps.

Regards

Dont forget to rate helpful posts

[pieterh]

I think you just need to specify the local controller as the anchor for the wlan.
The tunnel will end here and data is passed on to a dynamic interface ( vlan)

Ju will miss the extra security of passing data to a network segment separated by firewall.

Sent from Cisco Technical Support iPad App