06-06-2020 01:10 PM - edited 07-05-2021 12:08 PM
I have a used Cisco 5508 wireless controller. How do I see what boot image the controller is running on the graphical interface? I was on the page but I'm so new to this, I can't find the page again.
Thank you.
06-06-2020 06:07 PM
It should be on the Monitor page, In the latest version of codes, you have to click "Advanced" view in top right hand corner to go there.
HTH
Rasika
*** Pls rate all useful responses ***
06-07-2020 05:33 AM
Thank you for your assistance. I found what I was looking for. I was looking for the boot and IOS version of the connected access point. It's in:
wireless-------->All AP's------>general
boot version
IOS version
I'm learning slowly.
Thanks again.
06-08-2020 06:41 AM
06-09-2020 08:51 AM
Thank you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide