How to capture traffic of ISE Server

[shrijan]

Hello Everyone,

Can anyone tell me how to capture traffic of cisco ISE 3.0 server in cacti 0.8 Monitoring Tool?

i want to monitor total bandwidth being used by ISE server.

Thanks.

Shrijan

[balaji.bandi]

How to capture traffic of ISE Server 

Not sure you have asked this information before on other thread, what kind of traffic you looking to capture.

Cacti is NMS tool - ( so you can use ISE conencted port on the switch to monitor ?) or you looking something different ?

[shrijan]

@balaji.bandi 

Thank you for the reply.

Yes i am the one who asked similar question in other thread but did not receive convincing answer so raised another one.

Cacti is NMS tool - ( so you can use ISE conencted port on the switch to monitor ?) or you looking something different ?

Yes you are correct. Let say just wanted to capture the general in and out bandwidth traffic from the port of the switch for ISE connected. But since this ISE is installed as a VM, so is it still possible to capture the traffic of ISE server?

Thanks.

shrijan

[balaji.bandi]

You can configure ISE for SNMP and poll SNMP using Cacti

here is SNMP config on ISE :

https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/215521-configure-and-understand-snmp-traps-to-m.html

some Cacti templates :

https://forums.cacti.net/viewtopic.php?t=55155

Detailed admin guide :

https://www.cisco.com/c/en/us/td/docs/security/ise/3-0/admin_guide/b_ISE_admin_3_0/b_ISE_admin_30_troubleshooting.html

[shrijan]

@balaji.bandi 

Since i dont have CLI mode access, do you think GUI snmp configuration should work?

This is what i have tried so far. Kindly have a look at the attachments.

Also is there any way to check if port 161 is allowed in ISE from GUI?

Thanks.

Shrijan