cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1535
Views
25
Helpful
3
Replies

How to config standalone AP to working properly when WLC has shutdown

eeebbunee
Level 1
Level 1

Dear Engineer & Professional,

 

Can it be possible to config AP can working without WLC?

For now, our AP is sending and receiving data by a Cisco Wireless Controller 2504 so when WLC is down, all of AP stop working.

 

I would like to config AP to working properly in case of Controller disaster, can you tell me on how to?

 

 

1 Accepted Solution

Accepted Solutions

Flexconnect can help you pritty much. But, not perfect.  When the Access Point is in fleconnect mode, if it drops from the WLC, the radios keep working and users are able to use the network normally.  The limitation is that no new users are able to joing.

You can also have the possibility of configure a backup Radius server on flexconnect AP group and this way overcome the above limitation.

View solution in original post

3 Replies 3

it depends on your configuration mode. check below thread

https://community.cisco.com/t5/wireless/if-a-wlc-fails/td-p/2089671

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB

You can convert the AP in to the standalone mode and use without a WLC If you have just a single AP. 

 

Assuming you have multiple APs:

  1. 2504 controller "had" the option to use HA node with the part number AIR-CT2504-HA-K9. Unfortunately, it marked as "End-of-sale" since 2018. 
  2. You can also use a secondary controller in this case.

Note: Since all the 2500 series controllers are End-of-sale and going to be "End-of-Support" in 2023, you may need to upgrade the controller hardware in to new 9800 series controller or the Mobility express option. (check the AP compatibility).

 

 

Flexconnect can help you pritty much. But, not perfect.  When the Access Point is in fleconnect mode, if it drops from the WLC, the radios keep working and users are able to use the network normally.  The limitation is that no new users are able to joing.

You can also have the possibility of configure a backup Radius server on flexconnect AP group and this way overcome the above limitation.

Review Cisco Networking for a $25 gift card