how to reset the configuration on the 5760 controller

[jlarriega]

Happy Holidays Expert:

I locked myself out of the 5760 controller, this controller is not in production yet, it is connected in a Lab via a terminal server. I can access the controller via the terminal server or directly via the console cable to my Laptop. When I connect to the controller, I get placed in user mode but I can't go to enable/privilage mode. 

I like to know how I can go back to the intial autoinstall configuration or if I can remove some of the AAA and Radius commands that I think it is stopping me from going to enable/privilage mode.

I tried to boot and reset the controller after pressing the mode button but this method did not help.

I appreciate any input you may have.

Thanks;

Juan

[Scott Fella · Accepted solution]

Here is an older thread regarding this. Hope this helps. 

https://supportforums.cisco.com/discussion/12322496/wlc-5760-password-recovery-or-factory-reset

-Scott

[jlarriega]

Thank you Scott, the thread information was a great help.

[Scott Fella]

No problem. 

-Scott