cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1081
Views
0
Helpful
3
Replies
Loomit
Beginner

How to set up secondary WLC for all APs at once?

We added a new controller to the group which we want to be as a secondary for all WAPs. How can I set it up so that I don't have to go to each AP individually? Can this be done on the controller or from the WCS?

1 ACCEPTED SOLUTION

Accepted Solutions
Leo L
VIP Community Legend

WCS.

Configure > AP Template > Lightweight AP > Add Template > Make a name > Save

Under AP Parameters Tab, right-hand column, tick the "Controllers" and choose the secondary controller in the drop down menu.

To the left-hand column, scroll down and put a tick in the "Secondary Controller IP Address" and enter the IP address of the Secondary Controller.

Go to the Select AP tab and find the WAP based on the controller name (fastest way to find it) and choose them.  Go to the Apply/Schedule tab and click the "Apply" button.

All done.

View solution in original post

3 REPLIES 3
stefan.angerer
Beginner

Hi Peter,

bulk configuration of APs (e.g. setting primary/secondary controller) is a WCS/NCS/Prime Infrastructure feature.

If you want to test this software, Prime Infrastructure 1.2 comes with an built-in evaluation license for 100 devices (=access points) and 60 days (if I remember correctly). PI 1.2 is the successor of WCS and NCS.

regards

Stefan

Leo L
VIP Community Legend

WCS.

Configure > AP Template > Lightweight AP > Add Template > Make a name > Save

Under AP Parameters Tab, right-hand column, tick the "Controllers" and choose the secondary controller in the drop down menu.

To the left-hand column, scroll down and put a tick in the "Secondary Controller IP Address" and enter the IP address of the Secondary Controller.

Go to the Select AP tab and find the WAP based on the controller name (fastest way to find it) and choose them.  Go to the Apply/Schedule tab and click the "Apply" button.

All done.

Loomit
Beginner

Stefan, Leolaohoo

Thank you guys, I appreciate your answers. I used templates and it worked fine..

Create
Recognize Your Peers
Content for Community-Ad