Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
281
Views
0
Helpful
1
Replies

how to tie this together ?

michael.lussier
Level 1
Level 1

‎02-29-2008 11:29 AM - edited ‎07-03-2021 03:28 PM

I have a 4402 at an Off-site for internet access. This site is connected via frame relay T-3 to the primary site.The primary site has a 4402 as a mobility anchor on the FWSM.

The backup site has the same setup. How can I configure the Off-Site 4402 controller to use the Pirmary site and if unavailable to use the backup site ? Can this be done ?

Labels:
0 Helpful
1 Reply 1

michael.lussier
Level 1
Level 1

‎02-29-2008 11:31 AM

I dont want to do any kind of load balancing at all. just automate a failover senario.

If this can be done than can this also be done with a WiSM to these 2 locations as well ?

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card