Wireless

Hi,I just spent the whole day going through the old posts and can not find anything that is relevant to our issue.We just purchased batch of 20 1230 11b APs to be used a root APs in our wireless network. Our users connect to our network using non-Cis...

Pls can someone help. I cannot use my browser to access a wireless lan controller-2106 so i can complete configuration.I have entered the initial configs at startup via console with the wizard.I am running vista, i have made sure my PC is on the same...

This is an issue at a large containership facility.I am currently using 1231 AP's configured as Work Group Bridges that are located in the large container cranes, and they talk back to one of two 1231 Base Stations (AP's)which are connected to the wi...

is there any one can indicate me a good source of information about "wireless management console" any white paper link.for beginner!thanks in adavance

HI,I was just wondering if there is any suggested settings for configuring an Aironet 1250 series Autonomous AP to work in a N and G mix environment.Thanks

Hi all, i have a following problem, the Bridge 1410 with IOS 12.3(8)JA2 show a 251ºC on radio dot11radio0 and shutdown de radio, the 1410 is installed in the mountain with -16ºC on ambient. help me to resolve this problem.

Good day all.I'd be grateful if someone points me in the right direction here. I need to wire up, or rather, wifi'ize an entire condominium block, 12 floors, with a total of 72 units across all 12 floors.What would be the best way to do this? What ro...

Do anyone know what the bandwidth requirements are for connecting the Aironet 1242 Access Point to the 4404 Wireless LAN controller over MPLS/WAN.

Hello, I was wondering how many simultaneous users a 1100 AP could afford ? thanks; lachapelle

setup is cisco acs for authentication. clients use PEAP/WPA/TKIP. I need to assign a static ip address for a specific login as access will be restricted for this ip. the problem is the user can potentially connect to the wireless network obtaining a...

Scenario:AP: 1100 SeriesExternal Radius: ACSAuthentication type: LEAPProblem: wireless user is authenticated correctly but it is not possible to get an IP address from the IP pool configured on the ACS.

I've just upgraded our controllers from 4.1.185 to 4.2.130 and have noticed some new settings and features for Guest access, specifically on the interfaces and the wlans. Can some one point me to an updated guide on the explanation of these new addi...

I am working with a set of four 4402-50 controllers all running 4-0-219-0. The customer decided they did not want the Secondary and Tertiary controller settings configured on the AP so I am attempting to clear that information but I can't seem to do...

I can't find information about AIP-AP521 and AIP-AP1131 do they support 802.1p QoS and 802.11e Wireless QoS. I found one topic here: http://www.cisco.com/en/US/docs/wireless/access_point/350/configuration/guide/ap350ch1.html#wp1019578but it is not cl...