How to upgrade software in 9120AX Access points from tftp

[palani2010]

How to upgrade software in 9120 AX access point from tftp

[Mark Elsen · Accepted solution]

  - @palani2010                On the access point use the command : archive download-sw /no-reload tftp://<TFTP_IP_ADDRESS>/<FILENAME.TAR>

  M.

[balaji.bandi · Accepted solution]

if this AP running EWC or managed by Controller ?

if EWC : follow below guide :

https://www.cisco.com/c/en/us/support/docs/wireless/embedded-wireless-controller-on-catalyst-access-points/221705-upgrade-aps-in-non-homogeneous-ewc-netwo.html

if this is WLC 9800 managed then you can use Controller to upgrade AP :

https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/222431-upgrade-the-catalyst-9800-wlc-quick-st.html

Manual upgrade :

https://www.cisco.com/c/en/us/support/docs/wireless/wireless-lan-controller-software/221869-safely-upgrade-access-points-avoiding-i.html