Hello Everyone,
Today we have enabled Client-Link and Optimized Roaming features on Cisco WLC globally. Though it is visible from CLI that both the features are enabled properly.
Is there any kind of testing to verify the change in the network performance post enabling this features.
Client Link
(Cisco Controller) >show 802.11a
TI Threshold..................................... -50
Legacy Tx Beamforming setting.................... Enabled
Traffic Stream Metrics Status.................... Disabled
Expedited BW Request Status...................... Disabled
optimized-roaming
(Cisco Controller) >show advanced 802.11a optimized-roaming
OptimizedRoaming
802.11a OptimizedRoaming Mode.................. Enabled
802.11a OptimizedRoaming Reporting Interval.... 90 seconds
802.11a OptimizedRoaming Rate Threshold........ disabled
Regards,
Aniket P. Raut
