11-12-2004 12:27 AM - edited 07-04-2021 10:09 AM
After Upgrading my AP to c1100-k9w7-mx.123-2.JA' with the command 'ARCHIVE tar /xtract tftp://192.168.1.11/c1100-k9w7-tar.123-2.JA.tar flash:' I'm not able to access the html GUI although it is updated...
Any Suggestions?
11-12-2004 11:57 AM
FWIW, I had the same problem this morning.
After adding a USERNAME account thru the CLI
and rebooting to upgrade to the 802.11g card,
the GUI began working. I'm not sure if the
USERNAME or just the reboot fixed it??
HTH
mike
11-12-2004 01:42 PM
I suggest you to re-install 12.3(2)JA again by using "archive download-sw /overwrite /reload ftp://192.168.1.11/c1100-k9w7-tar.123-2.JA.tar.
I assume that you have enough room in the flash. Otherwise, you have to do a show flash: and delete all unncessary files.
11-13-2004 06:23 PM
I was reading the release notes for 12.3(2)JA and it says that this release supports SSL (https://)
Is this enabled by default?
Does this mean that to access the gui you need to enter
https://10.0.0.1 instead of
If this were the case the GUI would seem to stop working, but thats only if it is enabled by default
just my 2 cents
11-14-2004 07:43 PM
https has to be manually enabled (not the default).
Try turning off your pop-up blockers on your browser.
Good Luck
Scott
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide