cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
503
Views
0
Helpful
1
Replies

iot image for for raspberry pi 4 or raspberry pi 3 B+

mehdi-chitta
Level 1
Level 1

hi; can you please help me get the image that work with PL-APP on raspberry pi 4 (or raspberry pi 3 B+), i downloaded the version : "en_I2oT2.0_PL-App_Image.zip" that i found on netacad site, but it didn't work. i was following the document in joined piece and i stopped at page 10, where i couldn't connect the pi to PL-APP, because it didn't get an ip address, although WI-FI and DHCP are activated. Thank you.

1 Reply 1

Rich R
VIP
VIP

@mehdi-chitta please refer to https://www.netacad.com/support for how to get support with Networking Academy issues.

Review Cisco Networking for a $25 gift card