IP address of client and joined access point in WLC

[Integration Support]

Hey,

How to view IP addresses of joined clients and access points in WLC ? Is there any way ?

[Leo Laohoo]

Yes, use GUI.  On the main page of the WLC, click "Clients".  Depending on the firmware, the IP address of the clients and the AP joined will be displayed.

[Integration Support]

Hey

In GUI i can see only MAC addresses

See screenshots attached

[Leo Laohoo]

That's because the WLC is running an OLD firmware.  I believe starting from firmware 8.0 this feature is enabled.

[Integration Support]

I'm running 7.0.252.0

This is not the issue

I'm now can see the IP address of the APs . I just needed to click on detail (see screenshots)

or > Monitor > statistics > AP Join

Now I'm only stuck with clients IP addresses. I don't find the way to find clients IP addresses. Is there any command in CLI ?

[Leo Laohoo · Accepted solution]

Now I'm only stuck with clients IP addresses. I don't find the way to find clients IP addresses. Is there any command in CLI ?

And this is what I've been saying.  If you want a display which shows the client's MAC address, IP address, username, etc (see image below), then the controller firmware version will not support this.  The feature was enabled in 8.0.X.X.  Release Notes for 8.0.X firmware can be found HERE.

[johnlloyd_13]

hi,

try this command if it's available:

show ap join stats summary all

[i-chaudhry]

Thank you. "show ap join stats summary all" is what I was looking for as well.