Is Client Mode supported in Cisco CW9166 Access Point?

[PriyaKB]

Hello Community,

Is it possible to configure Cisco CW9166 Access point device as a client? Does this operating mode supported ?

I would like to use two CW9166 devices, one acting as an AP and other as a client.

Thanks

[Mark Elsen]

         - What do you mean by 'client mode' ?

M.

[PriyaKB]

The mode in which CW9166 device shall connect to SSID broadcasted by another CW9166 device (AP mode).

Please find attached.

[Mark Elsen]

             - It can't do that , what do you want to achieve ?

 M.

[Rich R]

What you are describing is a feature called Workgroup Bridge (WGB).
According to https://www.cisco.com/c/en/us/td/docs/wireless/access_point/feature-matrix/ap-feature-matrix.html#_Toc118737962 9166 should support WGB.
Refer to the config guide:
https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-9/config-guide/b_wl_17_9_cg/m_ewlc_wgb.html
https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-9/config-guide/b_wl_17_9_cg/m_mesh_ewlc.html