cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1425
Views
5
Helpful
2
Replies

Is there SHOW command for wireless AP transmitter power level?

rnlaberge
Level 1
Level 1

I have an autonomous wireless AP model c1121G, and an ISR model c851w.

Is there a CLI command that will show the radio's transmitter power level of these devices?

regards

1 Accepted Solution

Accepted Solutions

Madhuri C
Cisco Employee
Cisco Employee

Hi,


You could issue  'show controller dot11Radio0' or 'show controller dot11Radio1'


It shows current power set and allowed
power


Current CCK Power: 20 dBm Allowed CCK Power Levels: 7 10 13 15 17 20
Current OFDM Power: 17 dBm Allowed OFDM Power Levels: 7 10 13 15 17

Regards,
Madhuri

View solution in original post

2 Replies 2

Madhuri C
Cisco Employee
Cisco Employee

Hi,


You could issue  'show controller dot11Radio0' or 'show controller dot11Radio1'


It shows current power set and allowed
power


Current CCK Power: 20 dBm Allowed CCK Power Levels: 7 10 13 15 17 20
Current OFDM Power: 17 dBm Allowed OFDM Power Levels: 7 10 13 15 17

Regards,
Madhuri

Thanks for the reply, that is just what I needed.

regards

Review Cisco Networking for a $25 gift card