ISE and PI Integration

[Prasan Venky]

Dear All,

What are the configuration required on ISE to integrate with Prime 1.3.0.20?

On PI side, I have added ISE in the below path

Design-> External Management Servers -> ISE Servers.

Apart from this anything else to be done on PI..?

Thanks in advance.

[Prasan Venky]

Any Help ...? or i should move this discussion to other spaces

[grabonlee · Accepted solution]

Hi

There is nothing more to be done on the PI. Further configuration tasks are done on the ISE.

Cheers

[Prasan Venky]

Exactly.. What should i do on ISE...?

[grabonlee]

The stuff to do on the ISE is set up as a Radius Server for your client authentication. When ISE acts as a radius server, Prime Infrastructure collects additional information about these clients from Cisco ISE and provides all client relevant information to be visible in a single console on PI.

The point to remember is that PI is a management sloution for wired and wireless clients, while ISE acts as ACS and NAC combined. Recall that ACS on its own could not do posture validation without NAC.

Cheers

[nicanor00]

Hi

Prasan I also added ISE on prime and it is strange I dont see any change

Have you got additional information on client device from ISE ?

Have you done some thing else from the ISE ?

Please advise

[Prasan Venky]

There is no additional configuration required on Prime. Its like if you add ISE in prime, then you will be able to get information about clients(authentication logs) directly from prime.