cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
469
Views
1
Helpful
2
Replies

Joining a Catalyst 9130AX AP to a 9800-40 WLC

Heinz
Level 1
Level 1

Good Day,

Can any please supply a web link for joining instructions? 

This is a new WLC & a new AP.

Previously I joined AP's to a AIR-CT5520-K9 WLC and using the CLI command:

capwap ap primary-base *WLC* *IP*

This is clearly not working

Any feedback will be apricated

Regards

 

 

 

 

 

2 Replies 2

marce1000
VIP
VIP

 

                                  >....This is clearly not working
 - Why not  ? What are you observing and or post access point console log and controller log when the AP tries to join ?
                             Always better to include these in the initial post.

  Also review the current controller configuration with CLI show tech wireless  ; have the output processes with https://cway.cisco.com/wireless-config-analyzer
    When problems persist use these tools : https://logadvisor.cisco.com/logadvisor/wireless/9800/9800APJoin

    Adding also note this : https://www.cisco.com/c/en/us/support/docs/field-notices/724/fn72424.html

 

 M.

    



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

Rich R
VIP
VIP

What version of software is the WLC running? (show ver)
What version of code is installed on the AP? (this will be clear from the full console logs as requested by Marce)
Are any other APs joined to the WLC?

Review Cisco Networking products for a $25 gift card