(Cisco Controller) >show time
Time............................................. Sat Jul 15 13:33:08 2017
Timezone delta................................... 0:0
Timezone location................................
NTP Servers
NTP Polling Interval......................... 3600
Index NTP Key Index NTP Server NTP Msg Auth Status
------- ---------------------------------------------------------------
1 0 10.1.1.99 AUTH DISABLED*
APa493.4c38.0b67#reload
Proceed with reload? [confirm]
Writing out t
*Jul 15 13:37:06.270: %SYS-4-PUPDATECLOCK: Periodic Clock update with ROMMON failed, because size left in ROMMON (4294967295), size needed (29), error code (-1)
*Jul 15 13:37:06.271: %SYS-5-RELOAD: Reload requested by console. Reload Reason: Reload Command.
*Jul 15 13:37:06.271: %LWAPP-5-CHANGED: CAPWAP changed state to DOWNhe event log to nvram...
using eeprom values
WRDTR,CLKTR: 0x87000800 0x40000000
RQDC ,RFDC : 0x80000035 0x00000209
using ÿÿÿÿ ddr static values from serial eeprom
ddr init done
Running Normal Memtest...
Passed.
IOS Bootloader - Starting system.
FLASH CHIP: Numonyx P33
Checking for Over Erased blocks
......................................................................................................................................................................................................................................................
Xmodem file system is available.
DDR values used from system serial eeprom.
WRDTR,CLKTR: 0x87000800, 0x40000000
RQDC, RFDC : 0x80000035, 0x00000209
PCIE0: link is up.
PCIE0: VC0 is active
PCIE1: link is up.
PCIE1: VC0 is active
PCIEx: initialization done
flashfs[0]: 62 files, 15 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 32385024
flashfs[0]: Bytes used: 23254016
flashfs[0]: Bytes available: 9131008
flashfs[0]: flashfs fsck took 29 seconds.
Reading cookie from system serial eeprom...Done
Base Ethernet MAC address: a4:93:4c:38:0b:67
Ethernet speed is 100 Mb - FULL duplex
Loading "flash:/c1140-rcvk9w8-mx/c1140-rcvk9w8-mx"...#######################################################################################################################################################################################################################
File "flash:/c1140-rcvk9w8-mx/c1140-rcvk9w8-mx" uncompressed and installed, entry point: 0x4000
executing...
enet halted
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, C1140 Software (C1140-RCVK9W8-M), Version 12.4(21a)JA, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Mon 08-Jun-09 16:28 by prod_rel_team
Proceeding with system init
Proceeding to unmask interrupts
Initializing flashfs...
flashfs[1]: 62 files, 15 directories
flashfs[1]: 0 orphaned files, 0 orphaned directories
flashfs[1]: Total bytes: 32385024
flashfs[1]: Bytes used: 23254016
flashfs[1]: Bytes available: 9131008
flashfs[1]: flashfs fsck took 6 seconds.
flashfs[1]: Initialization complete....done Initializing flashfs.
Ethernet speed is 100 Mb - FULL duplex
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
cisco AIR-LAP1142N-N-K9 (PowerPC405ex) processor (revision B0) with 98294K/32768K bytes of memory.
Processor board ID FGL1620S4Y9
PowerPC405ex CPU at 586Mhz, revision number 0x147E
Last reset from reload
LWAPP image version 3.0.51.0
1 Gigabit Ethernet interface
32K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: A4:93:4C:38:0B:67
Part Number : 73-12836-04
PCA Assembly Number : 800-33767-04
PCA Revision Number : A0
PCB Serial Number : FOC16192EK0
Top Assembly Part Number : 800-33775-03
Top Assembly Serial Number : FGL1620S4Y9
Top Revision Number : A0
Product/Model Number : AIR-LAP1142N-N-K9
% Please define a domain-name first.
Press RETURN to get started!
*Mar 1 00:00:07.701: *** CRASH_LOG = YES
Base Ethernet MAC address: A4:93:4C:38:0B:67
*Mar 1 00:00:07.903: %LWAPP-3-CLIENTEVENTLOG: Read and initialized AP event log (contains, 1023 messages)
*Mar 1 00:00:09.952: %LINK-3-UPDOWN: Interface GigabitEthernet0, changed state to up
*Mar 1 00:00:09.973: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C1140 Software (C1140-RCVK9W8-M), Version 12.4(21a)JA, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Mon 08-Jun-09 16:28 by prod_rel_team
*Mar 1 00:10:54.011: %CAPWAP-5-CHANGED: CAPWAP changed state to DISCOVERY
*Mar 1 00:10:54.978: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0, changed state to up
*Mar 1 00:11:03.336: %DHCP-6-ADDRESS_ASSIGN: Interface GigabitEthernet0 assigned DHCP address 10.1.2.50, mask 255.255.255.0, hostname APa493.4c38.0b67
*Mar 1 00:11:13.516: %CDP_PD-2-POWER_LOW: All radios disabled - NEGOTIATED WS-C3750-48P (9c4e.20d5.ea0c)
Translating "CISCO-CAPWAP-CONTROLLER"...domain server (10.1.1.99)
Translating "CISCO-LWAPP-CONTROLLER"...domain server (10.1.1.99)
*Mar 1 00:11:23.962: %CAPWAP-3-ERRORLOG: Did not get log server settings from DHCP.
*Mar 1 00:11:23.963: %CAPWAP-3-ERRORLOG: Could Not resolve CISCO-CAPWAP-CONTROLLER
*Mar 1 00:11:23.965: %CAPWAP-3-ERRORLOG: Could Not resolve CISCO-LWAPP-CONTROLLER
APa493.4c38.0b67>
