Limiting Bandwidth Internet Access

[rogatien1977]

Hello,
I have a controller Anchor DMZ .
external users to connect to the company Guest SSID to connect to the Internet.
Can I make a limation bandwidth for these users.

[Prakash Parvathala · Accepted solution]

Yes You can do that by Configuring Quality of Service(QOS) Roles in controller and you can apply the bandwidth limitation

Go to the  QoS profile on your  controller and enter in values similar to this: note this would throttle  the average data rate to 250k

Per-User Bandwidth Contracts

- Average Data Rate: 250kbps

- Burst Data Rate: 500kbps

- Average Real-Time Rate: 250kbps

- Burst Real-Time Rate: 500kbps

Please refer the below link for configuration guidance.

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-0/configuration/guide/c70/c70ccfg.html#pgfId-1254532

[George Stefanick]

Prakash,

+1 and endorsement ..

You can also throttle at different parts of your network on the wire. However its always best as close to the edge has possible.