05-18-2017 01:30 AM - edited 07-05-2021 07:02 AM
Hi
In production Network two 5508 with AP sso is working there more than 100 APS .
In Need to add these WLC 5508 and APS and Maps.
How to add these APS and WLC
Solved! Go to Solution.
05-18-2017 02:58 AM
Hi Syed,
As per my knowledge: Cisco LMS is not the wireless infrastructure management software, like Cisco Prime Infrastructure.
I think LMS is for wired network so if you add a WLC it will not show the registered AP's or their details.
so I would recommend to join the WLC to Prime infrastructure (If you have it!!)
Regards
Dont forget to rate helpful posts
05-18-2017 04:27 AM
Ok.
If you add a WLC in prime then all AP which are connected to that WLC will also show in prime infrastructure automatically , means you dont need to add the APs manually in prime Infra.
Here is the link:
https://supportforums.cisco.com/document/122366/adding-controllers-prime-infrastructure
Question about reports for Floors for signal strength:
Yes, if you are inserting the correct map with correct dimensions then you can do it.
Regards
Dont forget to rate helpful posts
05-18-2017 02:58 AM
Hi Syed,
As per my knowledge: Cisco LMS is not the wireless infrastructure management software, like Cisco Prime Infrastructure.
I think LMS is for wired network so if you add a WLC it will not show the registered AP's or their details.
so I would recommend to join the WLC to Prime infrastructure (If you have it!!)
Regards
Dont forget to rate helpful posts
05-18-2017 04:20 AM
Thanks Sandeep,
Yes it is Prime infrastructure(version 3.1) when we add the WLC 5508 no need to APS
or
we need to add APs manually .
Can you please provide the documents for Prime Infrastructure for adding WLCS and APS.
one question.
if we upload the Maps for floors in Prime infrastructure we can generate the reports for Floors for signal strength
05-18-2017 04:27 AM
Ok.
If you add a WLC in prime then all AP which are connected to that WLC will also show in prime infrastructure automatically , means you dont need to add the APs manually in prime Infra.
Here is the link:
https://supportforums.cisco.com/document/122366/adding-controllers-prime-infrastructure
Question about reports for Floors for signal strength:
Yes, if you are inserting the correct map with correct dimensions then you can do it.
Regards
Dont forget to rate helpful posts
05-18-2017 05:03 AM
Thanks Sandeep
05-18-2017 06:46 AM
Hi
one question
In AP SSO they are two controllers so we are using one IP for both Controller
In Prime Infrastructure i will add one IP for Both Controller
And no need for CSV or RAR File
Please correct me if am wrong
05-18-2017 07:07 AM
Hi Syed,
You need to add both the controllers in Cisco Prime using their individual Management IP Address.
Regards
Dont forget to rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide