Lost access to WLC only console avaiable

[Saiganesh]

Hello, 

    I have lost access to my WLC9800, I am able to access the Console, can I get back the access, what would be the cli commands?

[balaji.bandi · Accepted solution]

You lost connection to GUI ? can you post-show run from console?

[Saiganesh]

Thanks Balaji

  I am able to show run

I was able to get back the WLCs I went to the config t # 

# ip http authentication local

and used the admin pw and reset the WLCs to access to TACACS+

[Scott Fella · Accepted solution]

Take a look at this thread.  You may an issue with your trustpoint.

CISCO 9800 wreless controller not getting the http or https access giving ERR_SSL_PROTOCOL_ERROR - Page 2 - Cisco Community