cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
880
Views
15
Helpful
3
Replies

Lost access to WLC only console avaiable

Saiganesh
Beginner
Beginner

Hello, 

    I have lost access to my WLC9800, I am able to access the Console, can I get back the access, what would be the cli commands?

 

  

2 Accepted Solutions

Accepted Solutions

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

You lost connection to GUI ? can you post-show run from console?

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

Scott Fella
Hall of Fame Guru Hall of Fame Guru
Hall of Fame Guru

Take a look at this thread.  You may an issue with your trustpoint.

CISCO 9800 wreless controller not getting the http or https access giving ERR_SSL_PROTOCOL_ERROR - Page 2 - Cisco Community

-Scott
*** Please rate helpful posts ***

View solution in original post

3 Replies 3

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

You lost connection to GUI ? can you post-show run from console?

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Thanks Balaji

 

  I am able to show run

I was able to get back the WLCs I went to the config t # 

# ip http authentication local

and used the admin pw and reset the WLCs to access to TACACS+

Scott Fella
Hall of Fame Guru Hall of Fame Guru
Hall of Fame Guru

Take a look at this thread.  You may an issue with your trustpoint.

CISCO 9800 wreless controller not getting the http or https access giving ERR_SSL_PROTOCOL_ERROR - Page 2 - Cisco Community

-Scott
*** Please rate helpful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers