11-11-2012 07:39 PM - edited 07-03-2021 11:01 PM
Hi,
I face with this simple problem...I have this LAP c1252 and it won't registered to the WCS/WLC....
My Tier3 like to telnet/ssh to it to diagnosis but I am stuck as in how to enable telnet/ssh access on the LAP c1252 (I have console access to the c1252)? I perform some searches in Google and found that you can only do it via the WCS CLI command...But the c1252 has not registered to the controller yet, how do I issue the command when the AP is not registered yet?
Seems like it's a chicken/egg issue to me?
Any advise/help will be greatly appreciated...
Solved! Go to Solution.
11-11-2012 07:44 PM
Take a look at this link
http://www.cisco.com/en/US/products/ps6366/products_tech_note09186a00808f8599.shtml
Sent from Cisco Technical Support iPhone App
11-11-2012 10:06 PM
ap#show capwap client rcb
11-12-2012 05:43 AM
When you console into the ap, the output you see when the ap has been rebooted and is in the join process will tell you what WLC it has joined if it does indeed join a WLC. Since you did have console access, you also could of entree the WLC IP address to tell the ap to join that specific WLC.
Sent from Cisco Technical Support iPhone App
11-11-2012 07:43 PM
You can't enable telnet unless the ap is joined to the WLC. What you need to do is console into the ap and reboot it. The output will tell you why it's not joining.
Sent from Cisco Technical Support iPhone App
11-11-2012 07:44 PM
Take a look at this link
http://www.cisco.com/en/US/products/ps6366/products_tech_note09186a00808f8599.shtml
Sent from Cisco Technical Support iPhone App
11-11-2012 08:22 PM
Thanks...is there a command that I can issue in the c1252 to see which controllers is it register to?
11-11-2012 08:46 PM
The command "sh logs" will tell you the joining process.
11-11-2012 10:06 PM
ap#show capwap client rcb
11-12-2012 05:43 AM
When you console into the ap, the output you see when the ap has been rebooted and is in the join process will tell you what WLC it has joined if it does indeed join a WLC. Since you did have console access, you also could of entree the WLC IP address to tell the ap to join that specific WLC.
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide