Mesh MAP Client Access: Traffic flow in FlexConnect Mode

[Tony Rosolek]

Hello world!

As mentioned in the subject, I want to know the traffic flow of a wireless client connecting to a "Mesh MAP" which is running in Bridge+FlexMode. The client is connecting to a FlexConnect SSID, therefore traffic shall be bridged "locally". 

If the MAP is powered via PoE injector, will the traffic be bridged to the power injector (#1) or via the wireless backhaul towards the RAP, where it then is bridged to RAPs trunk port (#2)?

I did not find the traffic flow in the documentation and I'm currently unable to test it by myself. 

Best Regards

[Jerome BERTHIER]

Hi

I'm wondering the same.

I would say that Flexconnect+bridge mode is a way to switch traffic between wireless clients and wired devices connected to the same MAP.

Refering to this picture, it is a way to mix red and green traffic locally at the MAP. Am I wrong ?

Regards