07-02-2019 08:49 AM - edited 07-05-2021 10:38 AM
I have two WLC 5520 and Flex 7500 both with FlexConnect but I have problems to configure Mobility Groups, what would be the recommendations to review ?, Multicast is not enabled only unicast because the Flex 7500 is not compatible with Multicast.
Firmware version is 8.3.143.0 in both WLC.
Solved! Go to Solution.
07-03-2019 11:44 AM
The solution was to eliminate check of New Mobility in the WLC 5520.
Controller > Mobility Management > Mobility Configuration > New Mobility > uncheck the box and apply.
Thank you for your comments.
07-03-2019 07:41 AM
07-03-2019 07:58 AM
The scenario is three WLC in total, two in SSO and one individual (Flex 7500), the MACs entered are the MAC of the SSO VIP and the MAC of the administration interface of the 7500 but it is not yet synchronized.
They are both in the same segment.
Controllers configured in the Mobility Group
IP Address Public IP Address Group Name Multicast IP MAC Address Status
10.13.251.159 10.13.251.159 APMobility 239.5.5.6 00:ee:ab:74:2d:c9 Up
10.13.251.172 10.13.251.172 APMobility 239.5.5.6 70:81:05:cf:06:e0 Control and Data Path Down
(Cisco Controller) >mping 10.13.251.172
Send count=3, Receive count=0 from 10.13.251.172
07-03-2019 08:31 AM
07-03-2019 11:44 AM
The solution was to eliminate check of New Mobility in the WLC 5520.
Controller > Mobility Management > Mobility Configuration > New Mobility > uncheck the box and apply.
Thank you for your comments.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide