Multiple vlans on aironet 1240 series

[Julio E. Moisa]

Good morning

I have configured my aironet 1242 in order to involve multiple ssid's, I put a management ip address on the interface BVI. The interface has been configured on trunk mode on the switch.

Everything works properly with the SSIDs but i am not able to reach the management ip address.

someone has a solution?

Thank you so much.

[fbarboza]

Here is a configuration example of an Access point with an IP address on the BVI1 for VLAN1 with 2 SSIDs one is linked to VLAN 1 and the other one is linked to VLAN 2.
Also each SSID is set to broadcast and with no security and using only the G radio.

As mention before, on the Cisco APs if the BVI1 has an IP address for VLAN 1 the native VLAN needs to be VLAN 1 and the bridge group to use is 1.

If the AP has an IP address for VLAN 30 then the native VLAN needs to be 30 and the bridge group to use is 1.

[fbarboza]

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801d0815.shtml