07-17-2012 12:04 AM - edited 07-03-2021 10:24 PM
Hi,
I have NCS 1.1 appliance and added a 5508 WLC running 6.0.199.4 code using snmpv3. Controller is added to NCS, but it doesnt show any AP's which are there on the controller. AP count is zero. I have another controller with code 7.0.230 added and showing AP's though. AP model is 1252. Any idea why this might be ?
regards
Joe
07-17-2012 03:09 AM
Your WLC controller.
Sent from Cisco Technical Support iPad App
07-17-2012 04:30 AM
hi Leo,
I think you didnt complete your reply
regards
Joe
07-17-2012 05:16 AM
Leo is suggesting that your wlc isn't sending the info. Have you tried to remove and add the wlc again? NCS dies support that code version on the wlc, but you never know.
Sent from Cisco Technical Support iPhone App
07-17-2012 06:43 AM
Yes, i guess the WLC isnt sending the info about AP's... is there anyway to debug that ?
yes tried removing and adding the WLC again, but same result.
07-17-2012 02:52 PM
I have NCS 1.1 appliance and added a 5508 WLC running 6.0.199.4 code using snmpv3.
1. Make it simple: Try SNMPv2 first.
2. IF SNMPv2 doesn't work, upgrade your firmware to 7.0.235.0 or 7.2.110.0.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide