06-18-2024 06:47 PM
i heard Mobility Express is so easy for user(not engineer) to install
in my case , Cisco think i am neither user and engineer just monster or alien ?
here is Korea, and i have running of 2 wireless cisco ap 3700
I have been stuck so strongly during the installation of 3800
No shown ssid or cisco provision ......
i found out below message during the booting
------ below -----------
[*05/10/2024 12:24:40.3496] DOT11_TXP[0]:Domain configured: 0 class:A
[*05/10/2024 12:24:40.4330] DOT11_TXP[2]:Domain configured: 0 class:A
[*05/10/2024 12:24:40.5135] DOT11_TXP[0]:Domain configured: 41 class:B
[*05/10/2024 12:24:40.9962] DOT11_TXP[1]:Domain configured: 41 class:B
[*05/10/2024 12:24:41.0878] USB Device Disconnected from the AP
[*05/10/2024 12:24:41.5044] DOT11_TXP[2]:Domain configured: 41 class:B
[*05/10/2024 12:24:42.8061] DOT11_DRV[0]: Stopped Radio 0
[*05/10/2024 12:24:42.8311] DOT11_DRV[0]: DOT11_DRV[0]: set_channel Channel set to 6
[*05/10/2024 12:24:43.7721] DOT11_DRV[1]: Stopped Radio 1
[*05/10/2024 12:24:43.7987] DOT11_DRV[1]: DOT11_DRV[1]: set_channel Channel set to 36
[*05/10/2024 12:24:45.5755] DOT11_DRV[0]: DOT11_DRV[0]: set_channel Channel set to 1
[*05/10/2024 12:24:46.3137] DOT11_DRV[0]: DOT11_DRV[0]: set_channel Channel set to 1
[*05/10/2024 12:24:46.3317] DOT11_DRV[0]: DOT11_DRV[0]: set_channel Channel set to 1
What is that ???? is that an eatable things ???
Is there anyone who can cook for me ????
06-18-2024 11:19 PM
- Have a checkup of the mobility express AP's configuration using ; WirelessAnalyzer input (procedure) for AireOs controllers
and feed the output from that into Wireless Config Analyzer
M.
06-20-2024 07:09 AM
I have never used the airprovision SSID. I always use console and SSH to do base config from CLI.
Once you have base config done you can connect to GUI over LAN and finish your setup.
So I suggest erase the config using mode button https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-2/b_Mobility_Express_Deployment_guide/b_Mobility_Express_Deployment_guide_chapter_0110.html#:~:text=Hold%20the%20button%20depressed%20for,will%20broadcast%20the%20CiscoAirProvision... or via CLI https://community.cisco.com/t5/wireless-mobility-knowledge-base/how-to-reset-a-wireless-lan-controller-wlc-to-factory-defaults/ta-p/3122866 and then use CLI for base config and then access the GUI via LAN to finish your config.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide