OEAP 600 - vWLC 8.0 - Split Tunneling with OEAP ACL & Network List

[edeloscobos]

Hello,

I'm trying to implement the new Split Tunneling model supported in 8.0 release code, using OEAP ACL's and Network Lists, but I'm unable to achieve this goal.

I'm seeing that whatever that I configure in OEAP ACL's, all traffic are "NAT-Routed" through WAN port at OEAP. I observed that on a Cisco ASA that provide the WAN to the OEAP. So, if I configure "deny", "permit" or "nat-route", the result is the same and traffic goes directly to the WAN, and internal traffic does not going trough CAPWAP tunnel.

Anybody have this model working now? because documentation not provide much troubleshooting info neither configuration guidance.

Regards.

[Rasika Nayanajith]

Pls attach a screenshot of your OEAP ACL used in this setup to see how it is configured.

HTH

Rasika

[edeloscobos]

Hello Rasika,

Sorry for answer until now, but I just replicated the scenario and still not work.

The SSID corporate subnet is 172.20.10.0/24

Thank you for your help!