08-09-2018 04:53 AM - edited 07-05-2021 08:57 AM
I bought an AIR-AP1852i-Z-K9 AP, it came from the factory in CAPWAP Lightweight
mode, so I did the conversion to Cisco Mobility Express Software.
I used the image AIR-AP1850-K9-8-5-131-0.tar
The conversion was successful, however the AP is not displaying the
CiscoAirProvision SSID.
Also the lights are flashing green, red, amber
In the terminal came to display the following message:
"Enabling mgmt via wireless
Enabling Provisioning SSID
SSID: CiscoAirProvision, Admin Status: 1, Interface Name: management, 802.11
Auth: WPA2-PSK, Wi-Fi Protected Access: Enabled
(Cisco Controller)
Cisco Aironet 1815 Series Mobility Express
Welcome to the Cisco Configuration Wizard Tool
Use the '-' character to backup
Would you like to finish autoinstall? [yes]: - "
Below is the result of the command show version:
cisco AIR-AP1852I-Z9 ARMV7 Processor rev 0 (v7l) with 997268 / 712580K bytes of
memory.
Processor board ID KWC220803JE
AP Running Image: 8.5.131.0
Primary Boot Image: 8.5.131.0
Backup Boot Image: 8.3.143.0
AP Image type: MOBILITY EXPRESS IMAGE
AP Configuration: MOBILITY EXPRESS CAPABLE
2 Gigabit Ethernet interfaces
2 802.11 Radios
Radio FW version: 5fd9df2ef70d087b014a57c17ecc942b
NSS FW version: wstephen,
Solved! Go to Solution.
08-09-2018 06:45 PM
08-09-2018 06:37 PM
Go through initial configuration via terminal session. Then access GUI of the controller using IP address you configured via CLI wizard
HTH
Rasika
*** Pls rate all useful responses ***
08-09-2018 06:45 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide