PI 3.0 Feature and Tech Templates = Can not see all WLCs to deploy to all

[ROB ADAMS]

Prime = 3.0

2504 WLCs = 8.0.121

Attempting to apply 2 different feature and tech templates to 4*WLCs.

To deploy, TemplateXXX I do see WLC#1 and not WLC#2, WLC#3 and WLC#4

Another TemplateYYY  it is the complete opposite.

I cannot see WLC#1 and see WLC#2, WLC#3 and WLC#4.

Why is this the case?

[Ryo Kato]

Sounds like the WLC does not have the requirement to deploy the template. For example you want to deploy a WLAN profile, but the interface is not present on the WLC.

Did you also snyc the settings from WLC, so the PI knows what's actually on the controllers?

[ROB ADAMS]

Realized the Wlans in question are not created on the WLCs, therefore the WLC was not showing under deploy.

What I am looking for is to create a new WLAN on the WLC using a PI template. Can this be done?

[Ryo Kato · Accepted solution]

Yes, you need to create & deploy an interface for the WLAN, then the WLAN itself. Optionally AP groups if you want to select which SSID to be served on which AP.