- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-08-2017 06:39 AM - edited 07-05-2021 06:40 AM
Prime = 3.0
2504 WLCs = 8.0.121
Attempting to apply 2 different feature and tech templates to 4*WLCs.
To deploy, TemplateXXX I do see WLC#1 and not WLC#2, WLC#3 and WLC#4
Another TemplateYYY it is the complete opposite.
I cannot see WLC#1 and see WLC#2, WLC#3 and WLC#4.
Why is this the case?
Solved! Go to Solution.
- Labels:
-
Other Wireless Topics
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2017 07:07 AM
Yes, you need to create & deploy an interface for the WLAN, then the WLAN itself. Optionally AP groups if you want to select which SSID to be served on which AP.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-08-2017 07:33 PM
Sounds like the WLC does not have the requirement to deploy the template. For example you want to deploy a WLAN profile, but the interface is not present on the WLC.
Did you also snyc the settings from WLC, so the PI knows what's actually on the controllers?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2017 05:40 AM
Realized the Wlans in question are not created on the WLCs, therefore the WLC was not showing under deploy.
What I am looking for is to create a new WLAN on the WLC using a PI template. Can this be done?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2017 07:07 AM
Yes, you need to create & deploy an interface for the WLAN, then the WLAN itself. Optionally AP groups if you want to select which SSID to be served on which AP.
