PI 3.0 restore 5508 config

mscherting · ‎01-04-2017

I had a 5508 die on me this morning. I need to restore a config archive from PI 3.0.0.0.78 onto a replacement 5508 ASAP.

Any easy way to do this? Or do I need to engage TAC?

SYS LED is flashing amber & ALM LED is solid amber.

Thanks!

marce1000 · ‎01-11-2017

- You'll need at least basic networking active on the replacement controller (mgmt/ip-setup) with same IP as the failed controller (ONLY when reachable from Prime, it will be possible to restore the config).

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '