pre-FCZ11 Cisco 1242 AP unable to join controller

[wirelessman]

This was solved with the following commands:

The commands are as follows
For Version 7.0.252.0, use this command: config ap lifetime-check {mic|ssc} enable
For Versions 7.4.140.0 and later, use this command: config ap cert-expiry-ignore {mic|ssc} enable

Are there any security risks if this command is left enabled?

[Rasika Nayanajith · Accepted solution]

No issues of using this work around.

But since 1242s are too old, better to change that hardware with newer AP platforms

HTH

Rasika

*** Pls rate all useful responses ***

[wirelessman]

Thank you, Rasika!

upgrade plan is otw. but until then, customer is still using the old 1242's.