03-01-2019 08:59 AM - edited 07-05-2021 09:57 AM
I have odd situation where about half of some new installed APs are not showing up in Prime 3.4 inventory. In addition to this, the half that did get discovered from the controller cannot be added to the map. It acts as though they will be added but then it returns to the map page normally with no new access points.
The controller does show to be in sync and audit status shows Identical.
When we experienced this issue in the past a simple reboot of Prime resolved it, but that did not work this time.
APs are 3802i
WLC is 8540 8.3.143.0
Cisco Prime 3.4:
Build | 3.4.0.0.348 |
Any ideas or anyone else experienced this issue?
Solved! Go to Solution.
03-05-2019 07:52 PM
Thank you for your suggestions, after digging deeper into the root of ade-os, I found that space was full on /opt. doing an ncs cleanup got us up and going again. I hope this is helpful to anyone else that runs into the same issue.
03-01-2019 04:23 PM
03-04-2019 02:37 PM
Thanks Leo, We will try that and I will post the results :)
03-04-2019 08:29 PM
I'm afraid we patched it and still seeing the same issue. Any other ideas?
3.4.1 Update 2
03-05-2019 02:06 AM
03-05-2019 07:52 PM
Thank you for your suggestions, after digging deeper into the root of ade-os, I found that space was full on /opt. doing an ncs cleanup got us up and going again. I hope this is helpful to anyone else that runs into the same issue.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide