Prime - No Adaptive wIPS Service enabled MSE selected

[marcoadolfo]

wer have a Prime 3.7, MSE 8.0, vWLC 8.5 and AP in Monitor Mode with SubMode wIPS enabled.

If I Run a Adaptive wIPS Alarm Report I receive the message :

No Adaptive wIPS Service enabled MSE selected.

I don't understand if the Adap wIPS is operational or only problems on the Report

[patoberli]

Is Prime also running the latest Service Packs and Patches?

I think it should be working with the devices you have, but haven't tested it (lacking a MSE). 

[marcoadolfo]

Hi patoberli
My Prime is at version 3.7.0.0.159 without any patches.
Tomorrow I will download patch PI 3.7 Update 03 and I will install it
I will update you

Thank you

[Grendizer]

Did you add the MSE to PI? Services > Mobility Services > Mobility Services Engines If so, what’s the status of the MSE from PI? Check PI 3.7 User Guide for those steps https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-7/user/guide/bk_CiscoPrimeInfrastructure_3_7_0_User_Guide.html

Check also the firewall between PI and MSE “if there is a firewall” following the doc here: https://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/113344-cuwn-ppm.htmlIf

if everything looks good, then just change the report criteria with a specific MSE instead of all MSEs.

[marcoadolfo]

everything looks good
I changed the report criteria with a specific MSE instead of all MSEs and now all work fine !!!

Thank you.