Prime obstacle height

[Jason Vanlandingham]

Is there a way to draw an obstacle on a Prime map and specify how tall it is? The situation is a building with a large outdoor walk-in cooler behind it. We are putting in outdoor antennas. I want to show how this cooler is blocking signal for antennas placed below its top, but show that if we place an antenna above it the signal will get by.

[Haydn Andrews]

From what i can tell Prime does not let you set the heights of walls for example ponywalls etc.

https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-0/user/guide/pi_ug/wireless-maps.html

The walls go ground to ceiling/ AP heights I believe

You can do this in Ekahau for predictive modelling.

You can set the AP heights in Prime

[patoberli]

I wouldn't try to do that in Prime, which is only guesswork and not using real measurement data. Better use Ekahau or similar, where you can actually measure the signal.