Re: Problem Configuring 1252s

Dennis Kline · ‎08-31-2010

I have a lot of 1200-series and 1100-series APs, but I've got several new 1252 APs I am configuring for the first time. Everything is going as expected until I get to the "Services" settings (for setting SNMP, HTTP, etc).

When I click on the Services tab (using the GUI), I get the Cisco logo and page header, but the rest of the page is blank. None of the sub-menus appear. I can successfully set the Services via CLI, but why isn't it showing up on the GUI ?

Screenshot below

.....dennis.kline@yahoo.com...(It takes an Act of God to fade a wireless path, but any fool with a backhoe can cut fiber)

Surendra BG · ‎09-03-2010

have you tried reloading the AP and tested??

Regards

Surendra

Regards
Surendra BG

Dennis Kline · ‎09-03-2010

yeah.. It's 6 APs, fresh out of the box.

.....dennis.kline@yahoo.com...(It takes an Act of God to fade a wireless path, but any fool with a backhoe can cut fiber)

Leo Laohoo · ‎09-03-2010

Maybe you just need to re-load the IOS.