Wireless

i have a 1130AG cisco acess point and it is impossible for me to set it up as a repeater to my verizon wireless at home. I added a ssid and wep key to it but evrytime i click on "repeater" it disables the ethernet port and it will not see my wirelles...

Quick question. We are trying to bring up a this type of card: WIC/VIC/HWIC Slot 3: 3G WWAN HWIC-EVDO Rev A/Rel 0/1xRTT-800/1900MHzFirst time for us, something one of our clients is trying out, but we have not used before. Do we need hi...

Dear if i have two controllers on different subnet and ONE SSID on different Subnet how can have roaming mobility between the two controller,some people recommended to use Mobility anchor but i dont know if true or what

Can I have APs that are ETSI and FCC register to same WLC, or is that where you can assign groups to APs in 5.x? Any best practices about having same WLC doing APs with ETSI/FCC with HREAP if hosted from a data center?

Hi,I have a little question. We have two Wireless LAN Services Module (WLSM) on two 6509. Firmware version on these cards: 2.4.1It's possible to use an AP 1250 (802.11n) with our WLSM cards?Thank you for your helpBests RegardsSam

when i put the CD in nothing appears and my wireless network is locked with a network key. my model number for my router is WRT54GS its a wireless-G Broadband router with speedbooster Lynkys. is there any way i can run the progam from the website? my...

WLC version 5.0.148.0When the client (mainly XP SP2) using IntelProSet connects to the wifi, the client hangs and requires power down. The radio management support has been enabled for sometime and the problem just happened from few weeks ago. No con...

I have a WLC 4402 and LWAPs 1240, a Laptop Dell is working properly but when I introduce an LWAP 1130 the laptop goes down until 1Mbps instead of working at 54Mbps. The Wireless card in the laptop is a mini_pci inalambrica wlan 1505, Does somebody h...

I created some ACS templates in WCS 5.1.151, when I view them in WLC 4.2.130 I see errors like Protocol = IP on IP or Protocol = 255 and the ACLs don't work.

We own a multi story building and have operations on two floors. On Floor 10 I have autonomous 1210 APs with ssid ZNDWireless running LEAP authentication with WDS. On Floor 4 I have deployed LWAPP 1242s with a WLC-4404 4.2.130 using the same ssid ZN...

Our 2710 location appliance has a flashing amber led. Is there a means from WCS to determine what the issue is? If not what command at the LA would show the problem? I have rebooted the unit.

Sorry for posting this twice:What is best practice for connecting bold users on our WLAN environment. We have dual band 1230 AP's. Are there any special setups need to be done?Subnets to use that will include data and voice.Thanks,

Hi all : We user WISM ver.5.0.148.2 , All AP is 1230 Series and Use Windows 2003 DHCP server.All AP cannot get IP after upgraded Lightweight from Autonomous IOS.But I found the DHCP is work if i use my notebook connect the same switch port and my no...