cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
395
Views
5
Helpful
1
Replies

procedure to change IP subnet for management interface of WLCs in HA SSO

Andrey128
Level 1
Level 1

I would like to clarify procedure to change IP subnet for management interface of WLCs in HA SSO.

The way I see it:

1) on primary WLC set new IP of management interface and redundancy-management interface

2) secondary reset to factory defaults?! Then set its basic network settings with new IP addresses and configure as HA SSO secondary

 

Are these steps correct or there is a better way to do this change?

1 Reply 1

balaji.bandi
Hall of Fame
Hall of Fame

Good document for your reference :

 

https://networksandrants.wordpress.com/2016/09/06/changing-ip-of-ha-wlc-controller/

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: