"Network Interfaces" isn't showing on the web interface Cisco Aironet

[glen4cindy]

I'm using a few Cisco Aironet 1142 ap's in my house configured with autonomous images.

The firmware version I have is c1140-k9w7-xx.153-3.JD17.

The problem I am running into is there is nothing at all under Network Interfaces on 3 of these ap's.

One shows the GigabitEthernet, Radio0-802.11N2.4GHz, and Radio1-802.11N5GHz.

I'm nearly certain all of them used to show these interfaces.

The 3 that do not show these are working properly.

Any direction someone could point me to so I could solve this would be apprciated.

I know these are old and EOL but they are working well other than this hiccup.

Thanks in advance.

[Rich R]

There's little value in learning autonomous AP IOS now because they're all past end of support.
The new generation of APs run a different (Linux based) operating system AP-COS and are all controller based (or Meraki cloud) so if you want to learn Cisco wireless that's what you should be looking at.