I need to reload a capwap ap from cli but I cannot figure out how to. reload command is gone. Shutting the switchport does not work cause it is plugged into a power injector. How can I reload v15.3 from cli?? It is not joined to the controller, so reload will not work from there. Thanks
Cisco IOS Software, C2600 Software (AP3G2-K9W8-M), Version 15.3(3)JA1, RELEASE SOFTWARE (fc1)
WAR572-APA123_A#?
Exec commands:
<1-99> Session number to resume
access-enable Create a temporary Access-List entry
access-profile Apply user-profile to interface
access-template Create a temporary Access-List entry
capwap capwap exec commands
cd Change current directory
debug Debugging functions (see also 'undebug')
dir List files on a filesystem
disable Turn off privileged commands
do-exec Mode-independent "do-exec" prefix support
dot1x IEEE 802.1X Exec Commands
eap EAP Exec Commands
enable Turn on privileged commands
exit Exit from the EXEC
help Description of the interactive help system
if-mgr IF-MGR operations
led LED functions
lock Lock the terminal
logging Handles logging operations
login Log in as a particular user
logout Exit from the EXEC
lwapconfig OfficeExtend AP configurations
lwapp lwapp exec commands
monitor Monitoring different system events
more Display the contents of a file
name-connection Name an existing network connection
no Disable debugging functions
partition Partition disk
ping Send echo messages
pwd Display current working directory
routing-context Routing Context
send Send a message to other tty lines
show Show running system information
systat Display information about terminal lines
terminal Set terminal line parameters
traceroute Trace route to destination
undebug Disable debugging functions (see also 'debug')
verify Verify a file
where List active connections
